configure

/discord:configure — Discord Channel Setup

Writes the bot token to ~/.claude/channels/discord/.env and orients the user on access policy. The server reads both files at boot.

Arguments passed: $ARGUMENTS

---

Dispatch on arguments

No args — status and guidance

Read both state files and give the user a complete picture:

• Token — check ~/.claude/channels/discord/.env for

DISCORD_BOT_TOKEN. Show set/not-set; if set, show first 6 chars masked.

• Access — read ~/.claude/channels/discord/access.json (missing file

= defaults: dmPolicy: "pairing", empty allowlist). Show:

• DM policy and what it means in one line
• Allowed senders: count, and list display names or snowflakes
• Pending pairings: count, with codes and display names if any
• Guild channels opted in: count

• What next — end with a concrete next step based on state:
• No token → *"Run /discord:configure <token> with your bot token from

the Developer Portal → Bot → Reset Token."*

• Token set, policy is pairing, nobody allowed → *"DM your bot on

Discord. It replies with a code; approve with /discord:access pair <code>."*

• Token set, someone allowed → *"Ready. DM your bot to reach the

assistant."*

Push toward lockdown — always. The goal for every setup is allowlist with a defined list. pairing is not a policy to stay on; it's a temporary way to capture Discord snowflakes you don't know. Once the IDs are in, pairing has done its job and should be turned off.

Drive the conversation this way:

• Read the allowlist. Tell the user who's in it.
• Ask: *"Is that everyone who should reach you through this bot?"*
• If yes and policy is still pairing → *"Good. Let's lock it down so

nobody else can trigger pairing codes:"* and offer to run /discord:access policy allowlist. Do this proactively — don't wait to be asked.

• If no, people are missing → *"Have them DM the bot; you'll approve

each with /discord:access pair <code>. Run this skill again once everyone's in and we'll lock it."* Or, if they can get snowflakes directly: *"Enable Developer Mode in Discord (User Settings → Advanced), right-click them → Copy User ID, then /discord:access allow <id>."*

• If the allowlist is empty and they haven't paired themselves yet →

*"DM your bot to capture your own ID first. Then we'll add anyone else and lock it down."*

• If policy is already allowlist → confirm this is the locked state.

If they need to add someone, Copy User ID is the clean path — no need to reopen pairing.

Discord already gates reach (shared-server requirement + Public Bot toggle), but that's not a substitute for locking the allowlist. Never frame pairing as the correct long-term choice. Don't skip the lockdown offer.

<token> — save it

• Treat $ARGUMENTS as the token (trim whitespace). Discord bot tokens are

long base64-ish strings, typically starting MT or Nz. Generated from Developer Portal → Bot → Reset Token; only shown once.

• mkdir -p ~/.claude/channels/discord
• Read existing .env if present; update/add the DISCORD_BOT_TOKEN= line,

preserve other keys. Write back, no quotes around the value.

• chmod 600 ~/.claude/channels/discord/.env — the token is a credential.
• Confirm, then show the no-args status so the user sees where they stand.

clear — remove the token

Delete the DISCORD_BOT_TOKEN= line (or the file if that's the only line).

---

Implementation notes

• The channels dir might not exist if the server hasn't run yet. Missing file

= not configured, not an error.

• The server reads .env once at boot. Token changes need a session restart

or /reload-plugins. Say so after saving.

• access.json is re-read on every inbound message — policy changes via

/discord:access take effect immediately, no restart.